+86 573-8422 6622
Jiashan SEBO Trading Co.,Ltd. supply slide bearings and wear plate, and also supply the Spherical Plain Bearings, Rod Ends, Bearing Housings and needle bearing.
SE-500 Solid-lubricating Inlaid Bushing
SE-010 Metal-Polymer Composite Bushing
SE-090 Bronze
Wrapped Bushing
SE-020 Marginal Lubrication Bushing
<
>
Products List
SE-GZ Needie Roller Bearing
Click here to more table size
SE-GZ05
The outer ring of drawn cup needle roller bearing is punched with the high-quality steel sheet. The outer ring has thin wall. The drawn cup needle roller bearing has the characteristics of small radial section area, large load carrying capacity, less inertia and economic manufacture. It is suitable for small section height, or when the housing bore isn't used for raceway, this type is recommended to use. The bearing is assembled into the housing bore under a certain pressure without further axial location.
The drawn cup needle roller bearing generally takes its shaft diameter as the internal raceway. However, the proper LR type inner ring can be used in accordance with application condition.
The drawn cup needle roller bearing has two structures-with retainer and with full of needles. They are divided into open-end type and close-end type. The structure with retainer has the single seal ring and double seal ring. The structure with full of needles has a large load carrying capacity.
SEBO can provide all drawn cup needle roller bearings listed in this catalogue, including standard size and non-standard metric size, and inch-series as well as the high-precision drawn cup needle roller bearings with special requirements such oil hole in outer ring, double-row needles, nylon retainer, inner ring, seal ring, etc. (special technical requirement on order).
Intruduction
In accordance with ZBJ11020 standard and inspection regulations of the world needle roller bearing manufacturing company (such as Japan NTN, KOYO, Germany INA, American TORRINGTON). Since the punched outer ring has thin wall and is easy to be deformed in heat treatment, it is unnecessary to inspect the outside diameter of bearing before installation. Only when the inspected bearing is pressed into the standard housing bore, the final size and geographic accuacy can be obtained. The tolerance of housing bore size shall be in conformity with regulations (see Table - 1). The inscribed circle diameter for needle roller will conform to the range of tolerance F8.
Inspection of Bearings
Copyright © 2014-2017 JIASHAN SEBO TRADING CO.,LTD. All rights reserved